Experimental and FEM study of partial roll bonding with prepared channels for wire position and the analysis of the wire effect on the entire system

Понедельник, 03 Июль 2017

Докладчик

Alexander Baun

Alexander Baun

  • Должность: студент
  • Организация: University of Paderborn
  • Город: Paderborn, Germany
  • Направление Алюминий, моделирование, прокатка, сталь, эксперимент


    Тип доклада

    Доклад по этапам работы

    Научный консультант

    Самсоненко Андрей Анатольевич

    Самсоненко Андрей Анатольевич

  • Должность: доц.
  • Звание, степень: к.т.н.
  • Организация: Национальная металлургическая академия Украины
  • Подразделение: кафедра "Обработка металлов давлением"
  • Город: Днепр
  • E-Mail: Этот адрес электронной почты защищен от спам-ботов. У вас должен быть включен JavaScript для просмотра. | Направление моделирование, низкотемпературная прокатка, охлаждение валков, прокатка, сталь, фасонный профиль

    Фролов Ярослав Викторович

    Фролов Ярослав Викторович

  • Должность: заведующий кафедрой
  • Звание, степень: проф.; д.т.н.
  • Организация: НМетАУ
  • Подразделение: кафедра "Обработка металлов давлением"
  • Город: Днипро
  • E-Mail: Этот адрес электронной почты защищен от спам-ботов. У вас должен быть включен JavaScript для просмотра. | Направление Другое, Спрейерное охлаждение, Трубы, Холодная и теплая пильгерная прокатка труб


    Аннотация

    The task was to continue with an already existing master thesis and to develop the process further.

    The first step was to insert two channels into the aluminum sheets, in which where aluminum wires placed.

    The problem was that the channels were not straight and did not have the same depth.

     On the other hand the channels in the opposite aluminum sheet must be at the same spot, for a good connection of the aluminum-wire-sandwich.

     The preparation of the test samples depends on many different factors and is a very difficult and long process. The repeatability of the experiment must be possible, too.

     As well the simulation of the process in QForm was a important part. Simulated were the basic partial roll bonding process with the wire between the sheets.

    Especially interesting was the position of the wire in and at the end of the process. The goal is that the wire build the edges of the inflatable channels and strengthens them.

    The inflation of the samples was also simulated.

    Комментарии (0)

    Оставить комментарий

    Please login to leave a comment.